Table of Contents
- 1 Why is my brake lights not working after replacing bulbs?
- 2 Why is my rear brake light not working?
- 3 Which fuse controls the brake lights?
- 4 Why are my dash lights and tail lights not working?
- 5 How do you replace the brake and turn signal light bulbs?
- 6 How to replace the tail light assembly on a Toyota Corolla?
Why is my brake lights not working after replacing bulbs?
Blown out light bulbs are the most common reason for why the brake lights not working but the tail lights are. Remove the screws from the bulb lens (which you can access through the trunk or see your vehicle repair manual to get the exact location). Choose the new bulbs of the same type and wattage.
Why is my rear brake light not working?
If one or more of your brake lights isn’t working properly, it could mean one of three things: The brake light system fuse is blown, the brake light bulbs are burned out or the brake light wiring switch is broken. All of these issues are easy to troubleshoot.
What fuse is the brake lights for a 2011 Hyundai Elantra?
The one that houses the fuse for the brake lights is in the passenger cabin. You can access it below the dashboard on the driver’s side. The name of the fuse is BRAKE SWITCH. You can verify which one it is by looking at the diagram on the inside cover of the fuse box.
Is there a fuse for each tail light?
The tail light fuse may be located in either the fuse panel in the front passenger side of your vehicle or in the main fuse box under the hood. Once you’ve opened either the panel or the main fuse box, locate the tail light fuse. If you’re unsure which one it is, use the owner’s manual for guidance.
Which fuse controls the brake lights?
The stop lamp fuse is in the left kick panel inside the vehicle. It is a 15amp fuse that powers the stop light switch on the brake pedal. The brake light switch sends power to rear brake lights.
Why are my dash lights and tail lights not working?
It could be that the dash and taillights share a common fuse. So, if you do find a blown fuse, you’ll need to track down the reason it blew in the first place. Other potential causes for your problem include a short somewhere in the circuit or a faulty light switch.
Why won’t my tail lights and dash lights work?
What’s the Chevy Elantra tail light bulb part number?
Replacement tail light bulbs for the ’11-’16 Elantra include the following with their part numbers: Brake # 2357, Turn Signal 1156A or 1156NA, Reverse 921 or W16W, and Parking or Rear Side Marker 168, 2825, 194 or W5W.
How do you replace the brake and turn signal light bulbs?
To replace the larger brake and turn signal light bulbs, insert the bulb into the socket, push down and rotate it 1/4 turn clockwise to lock it in place. Then insert any of the bulbs and sockets back into the tail light and rotate them 1/4 turn clockwise to lock them in place.
How to replace the tail light assembly on a Toyota Corolla?
To replace the tail light assembly, line up the silver metal threaded screw ends and grey plastic spikes with the holes in the rear corner of the vehicle. Carefully push the tail light back on to the vehicle and spin on the three black metal nuts by hand. Tighten the 3 nuts with the 10mm socket and ratcheting wrench to just past hand tight.
How do you change a tail light bulb on a Chevy Silverado?
Rotate the light grey base of the reverse light bulb socket 1/4 turn counter clockwise and pull it straight out of the assembly. Push a new # 921 or W16W light bulb straight into the socket, insert the socket back into the tail light housing and rotate it 1/4 turn clockwise to secure it in place.