Table of Contents
How much does a fiber laser cost?
Fiber lasers usually cost in the range of $20,000 to $45,000. Don’t get too caught up in the high priced fiber laser machines.
Why are CO2 lasers so expensive?
Unfortunately, CO2 lasers use significantly more power than fiber lasers, resulting in a higher cost of operation.
How much power does a fiber laser use?
Very low power consumption A 3000W fiber laser requires 10kW of electrical power plus 5kW for a chiller with a total of 15kW. $2,700 per year 15kW per hour at 12 hr. shift An equivalent 4000W CO2 laser and chiller combination could be as high 250kW for operation.
How are fiber lasers made?
Briefly, fiber laser light is created by banks of diodes. The light is channeled and amplified through fiber optic cable similar to that used for data transfer. The amplified light, on exiting the fiber cable, is collimated or straightened and then focused by a lens onto the material to be cut.
What can a 30w fiber laser cut?
30w fiber laser marking machine For cutting, most of customers cut gold and silver. 30w also has much good performance on that. It can cut maximum 0.7mm silver and 1mm gold. Based on those, no matter on performance, but also on cost, 30w is also the most popular type.
Is fiber laser better than CO2 laser?
Fiber can cut copper, brass and aluminum much better and more safely than CO2 because the beam is more readily absorbed and not reflected. Fiber laser operating costs are typically half of what a CO2 system can offer due to the lower electrical consumption and high electrical efficiency of Fiber lasers.
Can Fibre laser cut plastic?
With a fiber laser, you can mark a variety of different commercially used plastics, such as polycarbonate, ABS, polyamide, and many more with a permanent, quick, high-quality finish.
What can a 30 watt fiber laser cut?
What materials can fiber lasers cut?
Do fiber lasers lose power over time?
Laser power will likely decrease over time because laser optics and mirrors gradually absorb more laser light.
How deep can a 30W fiber laser cut?
therefore, if you use a 30W laser, it can engrave with a depth of 0.3mm at speeds higher than 4000 Millimeters per second with a decent engraving result.