Table of Contents
Why is it important to slow down the main engine rpm while water washing the turbo charger?
Why is it important to slow down the main engine RPM while water-washing the turbocharger? To protect the bearings . To protect the exhaust gas economizer. Some engine manufacturers recommend that washing of the compressor side is not carried out.
What is the main purpose of turbocharger water washing?
To ensure efficient functioning of turbocharger. To protect the compressor and turbine from contamination (Deposits).
Does a turbo need cleaning?
Starts here3:42Why Do I Need To Clean My Turbo? & HOW TO Clean YOUR TurboYouTubeStart of suggested clipEnd of suggested clip58 second suggested clipHere’s a view down the inside of the turbocharger. After i’ve cleaned. It. I gave it two blasts withMoreHere’s a view down the inside of the turbocharger. After i’ve cleaned. It. I gave it two blasts with the turbo cleaner. Then simply put your in intake pipes back together start your engine.
What are the safety precaution on performing overhauling turbocharger?
Great care must be exercised in the operation and maintenance of turbochargers. With regard to safety, it is essential to avoid the build up of fuel, cylinder or lubricating oil in the exhaust trunking before the turbocharger as it may result in combustion taking place in the exhaust manifold.
Do turbos get dirty?
Cleaning Turbo. A turbo provides extra power because it uses the exhaust gases to pump air into the engine block under pressure. But the exhaust fumes pollute the turbo enormously and especially when it doesn’t hit the high RPMs or when you drive shorter distances.
What is the main disadvantage of turbocharger water washing?
Engine speed has to lower. Thermal stress and corrosion usually occurred. Longer cleaning time.
How do I clean the air side of my turbo charger?
The Blower side of turbocharger is cleaned by fresh water. The engine is run at its full load rpm to achieve best possible cleaning. A container is fitted with an inlet line coming from the blower discharge side and the outlet line from the container or cylinder goes for washing blower side.
How often should you clean turbo?
Pour the content of a bottle in the fuel tank If you drive in town or only run short distances, use Bardahl Turbo cleaner every 5,000 km or once a year. If you often drive on highways, use Bardahl Turbo cleaner every 10,000 km or once a year.
How do you clean a turbo without removing it?
How To Clean a Turbo Without Removing It
- Park your car outside.
- Get a turbo cleaner and gloves.
- Warm up your engine.
- Disconnect the air inlet pipe.
- Spray the whole turbo cleaner.
- Leave the engine idling for 5 minutes.
- Rev up the engine.
- Reconnect the air inlet pipe.
What is turbo charger in main engine?
The turbocharger is an integral part of the ship’s marine engine as it reuses the exhaust gases in order to increase the overall efficiency of the engine. It consists of two parts – blower and turbine sides, which need equal attention while carrying out routine maintenance procedures.
Are we allowed to carry out turbocharger turbine side washing if it has not been cleaned for a long time?
The rotation of turbine side as a result of the exhaust gases flowing over it turns the blower and supplies air to the scavenge side. If the turbine side cleaning is not carried out then the fouling may lead to back pressure & surging resulting in breakage of turbine blades.
How often should you clean your turbo?
If you often drive on highways, use Bardahl Turbo cleaner every 10,000 km or once a year. It is recommended to drive occasionally at a lower engine rpm.