Table of Contents
Why is ground connection needed in simulating a circuit?
To simulate a schematic, it MUST have a ground. A simulation will not run if it has no ground. When you probe voltages in a simulation, all voltages are measured with respect to ground. Therefore before it can show you any meaningful voltage values, the simulator needs to know were that ground is in your circuit.
What is ground in PSpice?
Every circuit that is simulated on PSPICE must have a ground node indicated. This is done by entering the ground symbol. To place the ground, select Place→ Ground (or click on the ground symbol on the toolbar). Select the “Source” library and the ground part labeled “0”.
How do you simulate a circuit with PSpice?
To use PSpice, start with the PSpice Schematics program. When you start up you will get a screen which looks like this: To put in a component, use the Draw drop-down menu, and select Get new part (or use the shortcut Ctrl-G). This will bring up a dialog box which will allow you to select pats from libraries.
Why do we need to use Spice for simulation?
SPICE Simulation Program with Integrated Circuit Emphasis (SPICE) SPICE is a computer simulation and modeling program used by engineers to mathematically predict the behavior of electronics circuits. However, SPICE is generally used to predict the behavior of low to mid frequency (DC to around 100MHz) circuits.
Which library is the ground in in PSpice?
The only valid ground in a PSpice simulation is ground ‘0’. Either edit the ground symbol and change the names from GND to 0, or select ‘Place > Ground’, ensure that the source. olb library is configured from the \Capture\Library\PSpice\Source. olb’, which contains the 0 source.
What does it mean when a node is floating PSpice?
pspice error node is floating If you are using capacitors put a high resistor value (1E9 ohms) in parallel of each capacitor. If you are using a transformer, put the same resitor value between primary and secondary windings.
How does SPICE circuit simulation work?
The SPICE engine analyzes circuits based on the Kirchhoff’s current or voltage law. It assigns nodes to a circuit and attempts to solve the current and voltage values at the respective nodes. The SPICE simulator first generates nodal equations in the matrix format before solving them to obtain the values.
How to run a PSpice simulation project?
Simple Steps to run a PSpice simulation project. If you have properly executed installation in the file pspiceev.ini you can read the path where you installed the libraries: After installing the program and libraries, run the program: This is the OrCAD Capture Student version :
Pspice must have this ground in order for proper simulation. Otherwise it will give error result. Select the Groundbutton from the icon bar on the right. 5. The Place Grounddialog box will look like the one below if you are using PSPICE for the first time on your computer or if you are using a lab computer.
How to add markers for voltages and currents in PSpice?
If you wish to add markers for voltages and currents select “Markers” in the menu “PSpice”: Posted in OrCAD PSpice and tagged PSpice project simulation . This website uses cookies. Accept Cookie
What do I need to add to my PSpice library?
Source library: This includes power sources, such as DC voltage Vdc, AC voltage Vac, Sin wave voltage VSIN, etc. 4. You will also need to add a library to use grounds in your circuit. Pspice must have this ground in order for proper simulation. Otherwise it will give error result.
https://www.youtube.com/watch?v=NcKXIlCIj2Y