Table of Contents
What insulation has the highest R-value per inch?
Vacuum insulated panels have the highest R-value, approximately R-45 (in U.S. units) per inch; aerogel has the next highest R-value (about R-10 to R-30 per inch), followed by polyurethane (PUR) and phenolic foam insulations with R-7 per inch.
What is the R-value of 12 inch insulation?
Typically, the thickness and density of the material determine the R-value. The higher the R-value, the better the material will insulate. The number is presented per inch, so an R-value of 3.1 at 12 inches would provide an overall value of R-38.
Can I use r21 in 2×4 wall?
Use R-19 or R-21 kraft-faced fiberglass insulation for two-by-six (2×6) walls. This combination ensures that the insulation is neither too loose nor too tightly packed within the walls. Two-by-four (2×4) stud walls with true 4-inch depth.
What is the thickness of R13 insulation?
3 5/8 inches
R13 fiberglass batt insulation, typically used in walls and floors, is 3 5/8 inches thick, according to Energy.gov. Insulation needs and the effectiveness of the insulation vary depending on climate and material.
What is the best R-value per inch?
Open-cell spray foam is rated at about R-3.5 per inch while closed-cell spray foam is much more efficient at R-6.0 to R-6.5 per inch. Consider spray foam anywhere you need an air barrier as well as insulation.
How thick is R30 insulation?
Typical R-30 fiberglass insulation is 10-inches-thick. Prior to buying fiberglass insulation, it is important to measure the joint spacing you are working with. Note that the actual space between the framing members will be less than 16 or 24 inches, but the foam batts can easily be stuffed between these lengths.
How many inches of insulation is R30?
Fiberglass Chart
| R-Value | Thickness | Bags / 1000 Sq Ft |
|---|---|---|
| R49 | 16.25” | 22.6 |
| R44 | 14.75” | 20.1 |
| R38 | 12.75” | 16.8 |
| R30 | 10.25” | 13.0 |
What is the highest R-value for insulation on 2×4 wall?
Cavity insulation, like framing, has options. A 2×4 wall cavity can be insulated from R-13 to roughly R-25. A 2×6 wall can be insulated from R-19 to R-39.
What is the best R-value for wall insulation?
Typical recommendations for exterior walls are R-13 to R-23, while R-30, R-38 and R-49 are common for ceilings and attic spaces. See the Department of Energy’s (DOE) ranges for recommended levels of insulation below.
What is the highest R value for a 2×4 wall?
They are available in widths suited to standard spacings of wall studs and attic or floor joists: 2×4 walls can hold R-13 or R-15 batts; 2×6 walls can have R-19 or R-21 products.
Is R19 insulation better than R13?
There is a direct relationship between the amount of insulation and the amount of heat transfer. The bigger the R value, the better the insulation is at slowing down the heat transfer. So R19 is better insulation than R13, and R30 is better than R19. The larger the R value, the better the insulation value.