Table of Contents
Where can I use L293D IC?
L293D IC is a typical Motor Driver IC which allows the DC motor to drive on any direction. This IC consists of 16-pins which are used to control a set of two DC motors instantaneously in any direction. It means, by using a L293D IC we can control two DC motors. As well, this IC can drive small and quiet big motors.
What is L293D used for?
The L293D is designed to provide bidirectional drive currents of up to 600-mA at voltages from 4.5 V to 36 V. Both devices are designed to drive inductive loads such as relays, solenoids, DC and bipolar stepping motors, as well as other high current / high voltage loads in positive supply applications.
How many I O channels are present in L293D IC?
L293 and L293D Internal structure Their are total four channels.
How do I program a L293D?
Connect 5V to Enable 1 , Vss , and Vs on the L293D. Connect digital output pins (we’re using 6 and 7) to input 1 and input 2 on the L293D. Connect your Arduino’s GND to both GND pins on the same side of the L293D. Finally, connect output 1 and output 2 of the L293D to your motor pins.
Is DC motor An actuator?
Electrical DC Motors are continuous actuators that convert electrical energy into mechanical energy. The DC motor achieves this by producing a continuous angular rotation that can be used to rotate pumps, fans, compressors, wheels, etc.
How much voltage is L293D?
The L293D is designed to provide bidirectional drive currents of up to 600-mA at voltages from 4.5 V to 36 V. Both devices are designed to drive inductive loads such as relays, solenoids, DC and bipolar stepping motors, as well as other high-current/high-voltage loads in positive-supply applications.
What is VS and VSS in L293D?
Junior Member level 1. Joined Jun 8, 2013 Messages 15 Helped 1 Reputation 2 Reaction score 1 Trophy points 3 Location Jaipur Activity points 110. Why separate “Vs” and “Vss” at pin no. 8 and 16 respectively are used in L293D?
How many ground pins are in L293D IC?
16 Pins
L293D has 16 Pins in total which are as follows: Pin # 1 is Enable 1 which is used to turn ON or OFF the first H-bridge. Pin # 2 is Input1, which is the first Input for Motor1. It should be connected with a Microcontroller.
How many motors can be controlled using L293D?
L293D shield is a driver board based on L293 IC, which can drive 4 DC motors and 2 stepper or Servo motors at the same time.
What is the use of TT gear motor?
plastic gearbox motors (also known as ‘TT’ motors) are an easy, low-cost way to get your projects moving. This is a TT DC Gearbox Motor with a gear ratio of 1:48, and it comes with 2 x 200mm wires with breadboard-friendly 0.1″ male connectors. Perfect for plugging into a breadboard or terminal blocks.