What is the line side of a GFCI?
The “line” wires are the incoming power from the breaker box and the “load” wires are the outgoing power that travels down the circuit to the next outlet.
How do you know which is line or load?
Load Wire – Generally connected to the top half of your switch. If the wire is coming from the top of the switch box, it is likely your load wire. Line Wire – Generally connected to the bottom half of your switch.
How do you know which line is load?
Load Wire – Generally connected to the top half of your switch. If the wire is coming from the top of the switch box, it is likely your load wire. Line Wire – Generally connected to the bottom half of your switch. In some cases, line wires are marked with “line”, “pwr”, or a lightning bolt symbol.
Which wire is hot line or load?
Line is always hot. Load is the wire going from the switch to the device. Load will only be hot if the switch is closed.
How do you wire a GFCI plug?
Plug a lamp, radio or the GFCI tester into the outlet to test for power and make sure it’s off. Then unscrew and pull out the old outlet and count the number of wires in the box. Calculate the minimum box size required for all of the wires plus the GFCI (see “Required Box Size,” below).
Can you hook up a GFCI without a ground wire?
You can use a gfci receptacle without a ground wire. However along with the receptacle there should be little stickers, one of which stating that the receptacle is not grounded.
What does GFCI mean, and what do they do?
GFCI stands for ground-fault circuit interrupter and is part of an electric outlet. It is a device that stops the electricity when a imbalance happens between hot and neutral electric lines. It does this by comparing the electricity going to and returning from what is plugged in.
How many GFCI outlets on one circuit?
Bedroom Outlet Circuits Bedroom outlet circuits must be protected by an AFCI circuit breaker, or an AFCI receptacle outlet must be installed in the first position of all the other receptacle outlets. For bedroom areas it is common to have ten to twelve outlets on one circuit, which may be 15 amp or 20 amp.