Table of Contents
How can I make my kicks sound better?
Here are 7 great tips on how to make your kick drum sound better.
- PUSH THE MID FREQUENCIES. Contrarily to what most people think, the bass drum is not all about the low end.
- USE SATURATION.
- TRIGGERING.
- PARALLEL COMPRESSION.
- PARALLEL EQ.
- MAKE SPACE FOR THE LOW END.
- 808 KICK.
How do you make a kick drum stand out?
How To Get A Punchy Kick On Every Mix
- Choose the right kick sample.
- Use EQ to fatten/tighten up the kick.
- Use Compression to make the kick punchy.
- Make Sure Your Kick Sample Is In Mono.
- Use Sidechain Compression To Give Space To Your Kick.
How important is high pass filter?
A high-pass filter effectively cuts out the frequency response of a mic below a certain set point, allowing only the frequencies above this point to “pass” through as the audio signal. High-pass filters remove unwanted and excess low-end energy that otherwise degrades the audio signal.
What makes a good kick drum sound?
Fair enough! But the least you could do is try out a few different kick drum heads, and a few different beaters. If you want a lot of attack, look for a hard beater than adds some of the click sound to the drum. If you’re going for more of a soft pillow-y sound, then grab a felt beater to minimize the attack.
Should you compress a kick drum?
Just like a bass guitar, our kick drum’s “low-end” will require some compression to provide consistency. In other words, we need to “tighten-up” the “low-end” to bring out the “high-end” of our kick drum. Chances are your mix has more than enough “thump”, but it most likely lacks the “bite”.
Is a high pass filter the same as a crossover?
A crossover serves as a filter that blocks out unwanted frequencies to a speaker or group of speakers. High-Pass Filter: allows frequencies above the chosen cut off frequency to pass through to a speaker or group of speakers.
What frequency is a kick drum?
Kick drums can be tuned to have a fundamental frequency as low as 50 Hz and as high at 80 or 90 Hz depending on the drum size, the type of drumheads used and the style of music that is being played.
Should you use a high-pass filter on your music?
Humans can’t typically hear frequencies below 40 Hz. So it’s probably safe to apply a high-pass filter starting at that point on most instruments. In most music, vocals are the featured element. So they need to stand out. To make them pop, you can apply a high-pass filter, cutting 100 Hz and below.
What are the different types of audio pass filters?
There are two main types of audio pass filters: high pass and low pass. These terms are often confused. High pass filters allow high frequencies to pass through the filter, low pass filters allow low frequencies to pass through the filter.
How do I Make my kick sound better with a filter?
Using a high pass filter, go through all of the elements in the mix and remove any sub frequencies that could conflict with the kick and bass. In addition, if the kick or bass is generating useless rumble, then try cutting anywhere below 50 Hz to tighten up either sound.
Should you use a high-pass filter to shape the low end?
If the kick drum and bass guitar are getting drowned in your mix, you can use a high-pass filter to shape the low end. You can apply an HPF to other instruments to carve out room in the mix for the kick and bass. But why bother if the other instruments aren’t very bassy?